Kestrel
대시보드로 돌아가기
CVE-2026-19576MEDIUM· 6.8MITRENVD대응게시일: 2026. 10. 11.수정일: 2026. 10. 15.CNA: vulnerabilities@zephyrproject.orgAwaiting Analysis

The Goodix GT9xx input driver in drivers/input/input_gt911.c reads the touch point count from the controller's status register and masks it

Memory-Corruption

위협 신호 · CVSS · EPSS · KEV

정기 패치· 높은 악용 신호 없음
CVSS
6.8medium

이론적 심각도 점수

EPSS
0.2%상위 94.1%

30일 내 악용 확률 예측

KEV
미등재

실측 악용 기록 없음

권장 대응 기한차기 업그레이드 시CISA SSVC 기준

별도 긴급 패치 불필요 — 정기 시스템 업그레이드 주기에 맞춰 조치

완전 장악· KEV 미등재 · 자동화 어려움 · 완전 장악 · 내부 한정

CVSS 벡터 · 메트릭

악용 경로
공격 벡터물리
공격 복잡도낮음
필요 권한불필요
사용자 상호작용불필요
범위불변
영향
기밀성 영향높음
무결성 영향높음
가용성 영향높음
버전별 점수
CVSS 3.16.8MEDIUM· 악용성 0.9· 영향도 5.9
CVSS:3.1/AV:P/AC:L/PR:N/UI:N/S:U/C:H/I:H/A:H

약점 (CWE)

  • CWE-787

    경계 밖 쓰기 — 버퍼 범위를 벗어난 메모리에 써서 충돌·코드 실행으로 이어질 수 있음.

상세 설명

The Goodix GT9xx input driver in drivers/input/input_gt911.c reads the touch point count from the controller's status register and masks it with GT911_TOUCH_POINTS_MSK (0x0F), yielding a value of 0..15. In gt911_process() that value is used directly as the loop bound for filling point_reg[], a stack array sized to CONFIG_INPUT_GT911_MAX_TOUCH_POINTS, whose Kconfig range is 1..5 with a default of 1. No other check constrains the count; the driver relied only on a comment asserting that the controller had been programmed at init to report no more points than configured.

Each loop iteration issues an I2C read of eight bytes straight into point_reg[i], so a controller that reports more points than the array holds causes up to 112 bytes of peer-supplied data to be written past the end of the array, over the stack frame of gt911_process() in the system workqueue thread. Two further loops then read out of bounds from the same array. Triggering it requires control of, or the ability to substitute, the I2C touch controller — plausible on the many supported boards where the GT9xx panel is a pluggable display module or shield rather than an on-PCB part; a spoofed device need only answer the init probes with a supported product ID and a checksum-valid config blob. The same overflow can also occur non-adversarially, with a GT9271-class panel that ignores the driver's touch-count programming and reports up to ten points, or with bus corruption of the single status byte.

The impact is an out-of-bounds stack write with fully attacker-chosen content executing at kernel privilege, i.e. potential control-flow hijack on the host MCU, in addition to out-of-bounds reads and crashes. The attack vector is physical/local hardware access only; there is no network, USB, or syscall path to the defect. The fix clamps the reported count with min() against CONFIG_INPUT_GT911_MAX_TOUCH_POINTS before any array indexing.

AI 심층 분석

공격 시나리오 · 재현 가능한 PoC 페이로드 · 즉시 적용 가능한 차단 패치를 한 번에 받아 보세요. 보안 운영팀이 그대로 점검·티켓팅에 쓸 수 있는 형태로 정리해 드립니다.